If you pull a few more of the sensor leads from the green connector to ground, you won't be too annoyed by excessive warnings while you go about your testing.
2000+:
Blue connector:
Pin:
1 - positive (12 volts) — solid black
7 - ground (earth) — solid brown
8 - ground (coolant temp) — blue with brown stripe
9 - ground (earth) — solid brown
22 - ground (coolant level) — blue with yellow stripe
23 - positive (12 volts) — red with blue stripe
24 - ground (earth) — solid brown
25 - K-line (connect to 7 on OBD connector) — green with white stripe
----------------------------------------------------------------
OBD connector:
Pin:
4 - ground — solid brown
5 - ground — solid brown
7- k-line — solid green
16 - positive (12 volts) — red with blue stripe
---------------------------------------------------------------
Green connector:
Pin:
28- k-line-green/green tracer
You can pair the powers/grounds and k-lines together (powers can get paired, grounds can get paired. Do not actually connect the powers/grounds to each other).
I needed to connect some more wires to get the backlight working, and get rid of the FUSE/SICH warning message on the odometer.
I have connected +12V to pins 1, 15, 20 (not necessary with facelift cluster) and 23. If I don't connect the pins 15 or 23, the odometer has text "SICH". I think that if the cluster was coded to English, it would say "FUSE".
Ground pins are 7, 9, 24.
And for the backlights, I connected pins 26 and 27 from the blue connector to +12V. In the pre facelift cluster the backlights work if the pin 20 is connected to +12V.