|
Title: M3.8.3 06A.906.018.CG CW_CAN_R location Post by: airhaddock on November 04, 2018, 12:56:56 PM Hello,
I've been doing a lot of reading on this forum over the last few month to understand the Bosch M3.8.3 ECU. I have a Mk2 Golf with the AGU 1.8T engine fitted. I've been using an Arduino to create the ABS and Airbag CAN messages so the engine ECU runs without any DTCs. I did this as I thought the engine might use vehicle speed for fuel cut on overrun. Anyway it seems, it doesn't have any effect so I want to turn off the CAN monitoring in the calibration. For ME7 there are several threads on how to do this which describe modifying CW_CAN_R. It seems however, that the ME7 is quite different to M3.8.3 and I was unable to see any commonality when I started to look at memory addresses. The KP file I have has no obvious CW_CAN_R equivalent or similar mask. Does anyone have any experience with this or could give me a few ideas? Thank you. Here is the binary I am using: https://1drv.ms/u/s!AgolWdazE2cjgWvocn2j9Rb5fWi3 Title: Re: M3.8.3 06A.906.018.CG CW_CAN_R location Post by: airhaddock on December 10, 2018, 05:29:35 AM if this is useful to anyone I discovered the ABS mask is at 0x6D66.
Title: Re: M3.8.3 06A.906.018.CG CW_CAN_R location Post by: taylorcmq on July 13, 2019, 09:39:29 PM I need to turn off the fuel cut in overcoming, but I can not find the CWSAWE on my AGU 1.8T 150cv 06a906018CJ, do you have any idea where I can find it? or what other means can I use to go to sleep? I also did not find the TVSAG0, all other maps were found!
|