Title: 4B0906018DG Post by: antoffka666 on December 09, 2015, 01:47:36 AM Hello ! share if anyone has addresses in the 4B0906018DG I will be very grateful
Title: Re: 4B0906018DG Post by: ddillenger on December 09, 2015, 02:51:19 AM There is one on ebay, right now. It is in Santa Ana, CA. Nearest I can tell the addresses are:
33.7408° N, 117.8814° W Good luck! Title: Re: 4B0906018DG Post by: antoffka666 on December 09, 2015, 03:29:01 AM Sorry I can not be correctly written . I'm looking for addresses
KFZWOP 11x16 KFZWOP2 11x16 KFZW 12x16 KFZW2 12x16 KFMIRL 16x16 KFMIOP 11x16 KFLBTS 16x12 LAMFA 6x15 KFLDIMX 8x16 KFLDHBN 8x8 KFDLULS 8x8 KFLDRL 10x16 LDRXN 16x1 LDRXNZK VMAXNB VMAXTM 5x1 VNMX 1x1 NMAXDVG 1x8 NMAXGA 1x8 NMAX 1x1 NMAXDV 1x1 NMAXOG 1x1 DNMAXH 1x1 ITNMXH 1x1 TMOTNMX 1x1 TNMXH 1x1 CWDLSAHK CDKAT 1x1 CDHSH 1x1 CDHSHE 1x1 CDSLS 1x1 CLAHSH 1x1 CLAHSH2 1x1 CLAHSHE 1x1 KRKTE 1x1 Title: Re: 4B0906018DG Post by: adam- on December 09, 2015, 05:12:30 AM Would take 20 mins to define in WinOLS.
Title: Re: 4B0906018DG Post by: antoffka666 on December 09, 2015, 05:45:25 AM Would take 20 mins to define in WinOLS. I'm not that strong user WinOLS similarly I can not find KFLDIMX X-axis address MAP FOUND: KFLDIMX 8x16 @ 0x274C6 Y-13ACA , X-???? Do it by analogy to the standard firmware Title: Re: 4B0906018DG Post by: adam- on December 09, 2015, 05:52:35 AM Use "Connect Windows" in the third or fourth menu item at the top.
Title: Re: 4B0906018DG Post by: antoffka666 on December 09, 2015, 05:59:12 AM Use "Connect Windows" in the third or fourth menu item at the top. Not quite sure how to start to look for axes On my blog, I found a certain number of cards 018DF But with the complexity of the unit 018DG Title: Re: 4B0906018DG Post by: antoffka666 on December 09, 2015, 06:22:27 AM Friends ! thank you very much ! I finally understood how to look for similar cards! before that I was looking for them manually and spending on one card for half an hour!!!! ;D ;D ;D ;D
Title: Re: 4B0906018DG Post by: adam- on December 09, 2015, 06:41:28 AM Well done! :) When you've got some of the file defined, post it up. Keeps up the community! :)
|