Title: help with offsets Post by: luketomo on December 01, 2018, 03:03:16 PM evening all
im looking for a bit of help and guidance with using damos on a me 7.5 i think its correct one for the ecu do i need to put any offset or factors in? i have tried adding in LC from s4 wiki guide not sure if i have done this right? i also used the map loacation pack on S4 Wiki ? cheers luke Title: Re: help with offsets Post by: Blazius on December 02, 2018, 07:27:11 AM I am pretty sure you will need to write your own LC code, as copy paste from s4 wiki wont work for your own ECU.
Title: Re: help with offsets Post by: luketomo on December 03, 2018, 11:46:56 AM Hi thank you for your reply
i didnt think it was right thats why i wanted someone to check the file and the damos for me and tell me where im going wrong as i dont think im scaling the damos to the file right as the figures dont look correct, im new to this so on a big learning curve Title: Re: help with offsets Post by: nyet on December 03, 2018, 12:56:19 PM There is no point to doing any "scaling" until you write ASM.
Period. Title: Re: help with offsets Post by: luketomo on December 03, 2018, 01:15:04 PM sorry for sounding Dumb but what is ASM? like i said im new to this and first map iv looked at so needing a litle help and guidance
Title: Re: help with offsets Post by: nyet on December 03, 2018, 01:37:32 PM Actual code. You're not going to get anywhere with this, pick something much more basic to start.
Title: Re: help with offsets Post by: luketomo on December 03, 2018, 02:20:40 PM hi where do you recommend i start with or what to start with?
Title: Re: help with offsets Post by: nyet on December 03, 2018, 02:33:57 PM stage 1 boost increase on a car with one or more turbos.
Title: Re: help with offsets Post by: luketomo on December 03, 2018, 03:10:53 PM does that look like the right damos file? also it says its offset at 800000 does that seem about right?
|