SteveKen
Newbie
Karma: +1/-1
Offline
Posts: 20
|
|
« Reply #2 on: August 22, 2020, 10:36:32 PM »
|
|
|
I was able to read and write the eeprom using the argdub's tool in boot mode with the following settings:
--bootmode 95P08 --CSpin P6.3 (guessed on the CS Pin based on some searchign here)
It read the eeprom with no problem.
Writing went through the whole process but failed verification, so I thought that I was in the same boat as I was with the willem programmer.
I tried to read and write again using argdub's tool but it always errored out on me.
I was able ot quickly verify with vag k commmander and with the willem programmer and clip that the write did not fail and the bin file was changed.
Unfortunately, I can't really try anything since I'm just experimenting and dont even have a car to match the ECU.
|
|
|
Logged
|
|