Pages: [1]
Author Topic: coding out rear o2 and egt on a-box ecu  (Read 3513 times)
rotor_powerd
Newbie
*

Karma: +3/-0
Offline Offline

Posts: 16


« on: January 04, 2012, 05:44:30 PM »

Anyone done this? The only XDF's I can find for an A-box don't map the tables necessary to remove these sensors. Thanks.
Logged
rotor_powerd
Newbie
*

Karma: +3/-0
Offline Offline

Posts: 16


« Reply #1 on: January 04, 2012, 09:00:05 PM »

Nevermind, I found the M-box tune written for the Bosch MAF, so I grabbed it and coded out the sensors. Can anyone set the checksum in this file for me though? Thanks
Logged
rotor_powerd
Newbie
*

Karma: +3/-0
Offline Offline

Posts: 16


« Reply #2 on: January 06, 2012, 03:30:10 PM »

When I try to flash with the above file (With corrected checksums), it gives me a Data Transfer Failed error. If I try to Check If Flash Matches with any file other than the one that I read from the ECU, it fails. Any ideas?
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.012 seconds with 17 queries. (Pretty URLs adds 0s, 0q)