NefMoto

Technical => Data Logging => Topic started by: gregsback on June 05, 2012, 01:30:21 PM



Title: Can not connect with ME7 logger
Post by: gregsback on June 05, 2012, 01:30:21 PM
Dear all,
I tried to connect with ME7 logger but unfortunately got the attached failure message.
Does anybody know what went wrong?
many thanks in advance!!

Greg


Title: Re: Can not connect with ME7 logger
Post by: prj on June 06, 2012, 07:06:16 AM
551K, RS4.

Open the 8D0907551K.ecu file.
Change the first line under [Communication] to Connect      = SLOW-0x00

Go to the car, and put the ignition ON, but make sure the engine is not started.

Now start the logger, it should connect.
Now you can start the engine, and it will be logging.

Works on my RS4 like this.


Title: Re: Can not connect with ME7 logger
Post by: gregsback on June 06, 2012, 09:38:00 AM
Hi,
thanks for the advice, I will check it later and let you know.
0x00 is a setting which is not mentioned in the basic setup, only 0x11 or 0x01. How do you know the setting then  ???
many thaks in advance!!!!
greg


Title: Re: Can not connect with ME7 logger
Post by: prj on June 06, 2012, 11:51:45 AM
If you read through the ME7Logger thread, you will find it.
Good luck.


Title: Re: Can not connect with ME7 logger
Post by: gregsback on June 06, 2012, 01:19:16 PM
Yes. Perfect. :) :) :)
it works. What a great tool! reduced to the baisc but with enough felexibility to adopt to the requirements.
I'm happy to use it!!
many thanks!

Greg