NefMoto

ECU Files => Checksum Update Requests => Topic started by: A6_C5_Allroad on April 28, 2015, 11:22:59 AM



Title: Can I get a checksum confirmation, please?
Post by: A6_C5_Allroad on April 28, 2015, 11:22:59 AM
Can some please checksum this to confirm my checksum...??? Ran this through my checksum plugin and came through clean, but i still think there's something wrong....... as I'm getting the ""No Run after first run..no CEL...etc..."" and it is driving me crazy. cannot think of anything else than a bad checksum n the ECU 95040 eeprom bin.  Thanks!!


Title: Re: Can I get a checksum confirmation, please?
Post by: _nameless on April 28, 2015, 12:05:37 PM
Upload the orig to compare


Title: Re: Can I get a checksum confirmation, please?
Post by: ddillenger on April 28, 2015, 12:25:32 PM
All the checksums are correct in that file.


Title: Re: Can I get a checksum confirmation, please?
Post by: A6_C5_Allroad on April 28, 2015, 03:04:26 PM
All the checksums are correct in that file.

Thank you, DDillenger..!!   I'm wondering if the Flash BIN, although original 8D0907551"M" (M-Box as I bought it from forum member ) could be bad??   Looks like I'll have to remove the flash chip, reprogram and solder back on. Sucks, but has to be done.


Title: Re: Can I get a checksum confirmation, please?
Post by: A6_C5_Allroad on April 28, 2015, 03:18:10 PM
Upload the orig to compare

Marty, ATTACHED is the "original BIN" that is on the Flash Chip ( am29f800BB-70SE ).  So are you thinking that it may be the flash BIN and not the 95040 BIN..??


Title: Re: Can I get a checksum confirmation, please?
Post by: ddillenger on April 28, 2015, 04:50:12 PM
If the car runs, then shuts off, I'd check the soldering :)


Title: Re: Can I get a checksum confirmation, please?
Post by: A6_C5_Allroad on April 28, 2015, 06:58:35 PM
If the car runs, then shuts off, I'd check the soldering :)

DDillenger, I'll do that. But, wouldn't the car simply not start if there were a solder issue??  Also, what about how I need to disconnect the ECU, I suppose to allow caps to discharge, before it will start again.  ( If I leave the ECU in the car, after the engine dies, i cannot restart the car.)

I'll do what you said, because you are always right and your advice has always panned out for me.

Thank you for your attention to my problem/s