|
Title: Audi 3.0V6 ASN Me7.1.1 Cat + lambda off. Post by: aroo84 on March 31, 2016, 03:02:25 PM He everyone.
This forum is awesome, full of useful knowledge :). This is my first post. I'm work with car electronics for 5 years. I'm trying to do Cat off and disconnect rear lambdas (Custom downpipe). Car is Audi 3.0 V6 ASN with A/T. So far I found and change these parameters. Please check this, maybe I'm wrong. 22010 01 -> 00 cdkat 22012 01 -> 00 cdlash 2200c 01 -> 00 cdhsh heater diag 2200d 01 -> 00 cdhshe 22582 01 -> 00 cwdlsahk 22029 0x33 -> 0x11 CWKOLNS 18E29 03 -> 00 err. class P1118 18E28 03 -> 00 err. class P1118 18E2A 03 -> 00 p1122 18E2B 03 -> 00 p1122 Error code class table 18DE3 -> 18FF6 P-codes table 190A8 Driving fine and has no fault codes after that but... I can't find CLRHK (or CLRSHK - car has wideband lambda) so I don't sure that post cat correction is off. How Can I check this with VCDS? Readiness show failure in Oxygen Sensors and Catalitic Converter, is that normal? In Meas. block 046 shows always "Test OFF" for Cat. Block 043 and 044 (sensor agning) - B1S2 OK, B2S2 OK I'll be glad for any help or hint. Once again, great forum, good Job! :) Title: Re: Audi 3.0V6 ASN Me7.1.1 Cat + lambda off. Post by: ddillenger on March 31, 2016, 04:50:57 PM Don't forget ESKONF. There are 8 variations, starting at 0x1121B. Use that, and revert your error class changes.
I took a quick look, but didn't find CLRSHK. If you want to run the US version, ending in 559E I will give you the address. |