|
Title: S4 ECU Me7.1.1 in an VR6 24V possible? Post by: Jim_Coupe on May 02, 2016, 10:50:15 AM Hello, im sure this has been asked b4 but is it possible to run an Audi S4 ECU with 3.2 VR6 24V engine harness? Trigger sensors are probably diffrent?
Title: Re: S4 ECU Me7.1.1 in an VR6 24V possible? Post by: cerips on May 02, 2016, 12:44:13 PM The S4 has a bank angle of 90 degrees, the VR6 has a bank angle of 15 degrees.
Title: Re: S4 ECU Me7.1.1 in an VR6 24V possible? Post by: Carsinc on May 02, 2016, 09:23:33 PM The S4 has a bank angle of 90 degrees, the VR6 has a bank angle of 15 degrees. I do not understand what this has to do with it? I'm pretty sure the crank trigger wheels are different and the cam sensors are also different. Is this for a forced induction 3.2 motor? Title: Re: S4 ECU Me7.1.1 in an VR6 24V possible? Post by: Jim_Coupe on May 03, 2016, 12:06:30 AM Is this for a forced induction 3.2 motor? Yes im just laborating and experimening some.. Im searching for which engine i shall build in an Audi 90 Coupe RWD rearmounted engine solution. And i have an 3.2T today with NA ECU in my other daily driver. But was curious of the S4 ECU. If one could just adjust and install identical triggers it would probably work. Ive also been laborating with an BMW e36 Ms41.0 for a VR6 and tune it via RomRaider. Title: Re: S4 ECU Me7.1.1 in an VR6 24V possible? Post by: adam- on May 03, 2016, 05:03:14 AM http://nefariousmotorsports.com/forum/index.php?action=printpage;topic=8827.0
Already asked. Title: Re: S4 ECU Me7.1.1 in an VR6 24V possible? Post by: Jim_Coupe on May 03, 2016, 10:48:56 AM http://nefariousmotorsports.com/forum/index.php?action=printpage;topic=8827.0 Already asked. Ahh there it was.. Got it.. |