|
Title: 98 b5 a4 1.8t aeb - can't read address 0x11 Post by: TheCream on October 31, 2016, 05:24:39 PM I've tried every memory layout, and every Baud rate, fast and slow init, with key cycles and close and restart program each time, and this is my result:
Validated FTDI device is in dumb mode. Disconnected Connecting... Starting slow init connection. Connecting to address 0x01. Slow init succeeded. Switching to KWP1281 session. KWP1281 connect info: 8D0907557P 1.8L R4/5VT MOTR HS D04 Ë Connecting to address 0x01. Slow init succeeded. KWP1281 connect info: 8D0907557P 1.8L R4/5VT MOTR HS D04 Ë Connecting to address 0x11. Slow init failed. Disconnected Title: Re: 98 b5 a4 1.8t aeb - can't read address 0x11 Post by: TheCream on October 31, 2016, 05:31:41 PM ecu is 8d0907557p. can't read the ecu...any suggestions? search netted nothing for this ecu or even the 'm' box.
Title: Re: 98 b5 a4 1.8t aeb - can't read address 0x11 Post by: _nameless on October 31, 2016, 05:58:00 PM Aeb is m5.92 not me7. Nefmoto is only for me7. Unless you pull the chip on the board you won't be able to read out a file. Mpps will port flash but will not read.
Title: Re: 98 b5 a4 1.8t aeb - can't read address 0x11 Post by: TheCream on November 02, 2016, 05:22:14 PM Ahh. Thank you. I was wondering if this was one of the old chip-a-roos...I wasn't too keen on removing my ECU as it has been raining here. Will just have to wait and pull it later. How lame is it I get one just old enough not to be able to tune myself, and my GLI has a commercial tune on it...gheyyy. Oh well. Thanks again.
|