|
Title: lambda sensor 1 broken bosch me 7.3.1 Post by: etneo on February 15, 2017, 10:34:49 AM Hi guys, i have an alfa 147 2.0 gasoline with bosch me7.3.1 ecu. I dasabled rear 02 sensor by map because i remove the catalist. Now i want map ecu,but when i do log i see that the first lambda sensor don't work good and the ecu stay always in open loop mode and don't go in closed loop mode. Now i have dubt. What it's the strategy map for make afr? The ecu follows normal map open loop lamfaw and Lambts or only Lambts or other "protection map"? So if the ecu use normal open loop map i can to set afr by lamfaw or lambts and don't change 02 sensor. Thanks
Title: Re: lambda sensor 1 broken bosch me 7.3.1 Post by: vwaudiguy on February 15, 2017, 11:45:09 AM I dasable rear 02 sensor by map because i remove the catalist. No need to do this in order to run without a cat. Can you post any of your files/ definitions? Title: Re: lambda sensor 1 broken bosch me 7.3.1 Post by: etneo on February 15, 2017, 11:58:28 AM My problem is the first sensor (pre cat) and non second that i desable d by map.the ecu run in open loop at partial load and i don't know how it makes afr: with normal map lafwa lambts, only lambts or other protection map.
Title: Re: lambda sensor 1 broken bosch me 7.3.1 Post by: c0r0n4 on February 16, 2017, 05:14:48 AM This approach works on ME7.1.1, i suppose it will on yours too.
FKHABMN S -->0 CLRSHK --> disable, uneven (eg 10 to 11 (hex)) AHKATMN --> increase the secondary air system should be disabled as well (CWKONABG; CDSLS). Title: Re: lambda sensor 1 broken bosch me 7.3.1 Post by: etneo on February 16, 2017, 08:59:38 AM But if i If physically detachment the first o2 sensor how thw ecu make afr at midle and high load ? With normal open loop map or protection map?
Title: Re: lambda sensor 1 broken bosch me 7.3.1 Post by: vwaudiguy on February 16, 2017, 11:26:36 AM But if i If physically detachment the first o2 sensor how thw ecu make afr at midle and high load ? With normal open loop map or protection map? You need to keep the primary 02 sensor(s) installed, and coded in. Title: Re: lambda sensor 1 broken bosch me 7.3.1 Post by: etneo on February 18, 2017, 12:06:36 PM If i haven't installed primary o2 sensor the ecu run in limp mode?
Title: Re: lambda sensor 1 broken bosch me 7.3.1 Post by: nyet on February 18, 2017, 05:35:02 PM If i haven't installed primary o2 sensor the ecu run in limp mode? Why would anything run right w/o the primary o2 sensor? |