|
Title: need help m3.8.3 immo Post by: gareth_iowc on May 16, 2017, 01:27:38 PM hi all,
so i successfully read the eeprom from my me7.5 immo and flashed a de-immob bin and it worked ok. no i'm trying to do the same for my friend and having a little trouble. ECU - 06a 906 018 R Immo Chip - 24c02 i have my test clip attached but when i read it all i get is 0's! The device family i have chosen is "24lc" and the cloest device "24lc02b" is this right? I'm still learning but getting there :) any help would be great. thanks gareth Title: Re: need help m3.8.3 immo Post by: gareth_iowc on May 16, 2017, 01:44:32 PM here is a pic
Title: Re: need help m3.8.3 immo Post by: bennyboi on May 17, 2017, 12:03:14 AM remove the chip from the board as it can also try and power up the MCU when trying to read.
Title: Re: need help m3.8.3 immo Post by: gareth_iowc on May 17, 2017, 12:42:05 AM Mcu?
My soldering skills are not up to scratch. Getting that off seccsessfuly would be a challenge. The test clip was ok with the me7.5 :) Title: Re: need help m3.8.3 immo Post by: prj on May 17, 2017, 01:57:31 AM Not going to work on this board, you are trying to power the entire ECU through the testclip.
Desolder. BTDT. |