|
Title: coding out rear o2 and egt on a-box ecu Post by: rotor_powerd on January 04, 2012, 05:44:30 PM Anyone done this? The only XDF's I can find for an A-box don't map the tables necessary to remove these sensors. Thanks.
Title: Re: coding out rear o2 and egt on a-box ecu Post by: rotor_powerd on January 04, 2012, 09:00:05 PM Nevermind, I found the M-box tune written for the Bosch MAF, so I grabbed it and coded out the sensors. Can anyone set the checksum in this file for me though? Thanks
Title: Re: coding out rear o2 and egt on a-box ecu Post by: rotor_powerd on January 06, 2012, 03:30:10 PM When I try to flash with the above file (With corrected checksums), it gives me a Data Transfer Failed error. If I try to Check If Flash Matches with any file other than the one that I read from the ECU, it fails. Any ideas?
|