|
Title: delete hex line in 2step & LC script Post by: naach_ on February 06, 2018, 11:54:24 PM hello guys, I've been reading the post about the launch control & NLS script for a long time, which needed to eliminate one of the hex lines that the script writes for the system to work correctly. today I can not find that post to correctly perform the integration of the system, can someone remind me what was the post or the correct way to eliminate that hex? Thank you very much and greetings
I attach the file with the implanted route and the directions that CMD gave me. regards Title: Re: delete hex line in 2step & LC script Post by: KasperH on February 07, 2018, 09:25:17 AM Is it the script with coolant temp check?
Title: Re: delete hex line in 2step & LC script Post by: naach_ on February 07, 2018, 02:43:28 PM Is it the script with coolant temp check? yes, my script use temp to workTitle: Re: delete hex line in 2step & LC script Post by: KasperH on February 07, 2018, 03:32:00 PM Delete the line of code with the coolant temp check,
and match up routine address again. One way or the other Title: Re: delete hex line in 2step & LC script Post by: naach_ on February 08, 2018, 05:29:32 PM Well guys, I think I already have it, would you give it a look for me? I think that everything is correct, the line suppressed, ftomn to 1 ... could I sing victory?
Title: Re: delete hex line in 2step & LC script Post by: KasperH on February 08, 2018, 06:35:12 PM Not if FTOMN=1 :)
|