|
Title: Searching for xdf file for A4 1.8T AT AMB'02 8E0909518F SW 360910 Post by: Tim Taler on May 07, 2018, 01:29:47 AM Hello!
I'm looking for a XDF file for a Audi A4 1.8T AT (Tiptronic) with AMB engine. All i have found are not the right i believe. Are ECU data or the addresses of the individual maps from cars with automatic transmission the same as from manuell transmission? I can not get any further :( , ask you for help... Thanks! Title: Re: Searching for xdf file for A4 1.8T AT AMB'02 8E0909518F SW 360910 Post by: Tim Taler on May 07, 2018, 02:04:10 AM Sorry, here is my currently ECU file.... Title: Re: Searching for xdf file for A4 1.8T AT AMB'02 8E0909518F SW 360910 Post by: gt30avant on May 11, 2018, 03:13:48 AM maybe this will help
Title: Re: Searching for xdf file for A4 1.8T AT AMB'02 8E0909518F SW 360910 Post by: Tim Taler on May 14, 2018, 11:11:39 PM Everything helps, thank you very much! I think i must disable torque monitoring and can not found TMNSMN TANSMN NASNOTKL Is Table KFMIZUOF adress correct in this XDF? Problem i have is, if i have WOT and boost over 21 psi, i get a load error "18265.P1857 Load Signal error" to engine control unit and "Load Signal error message from engine control unit" + "01119.Gear recognition signal" to gearbox unit. And engine goes in one second in limp mode...no boost. If i delete errors, i have boost for one second and again limp mode..... Anyone can help? Title: Re: Searching for xdf file for A4 1.8T AT AMB'02 8E0909518F SW 360910 Post by: Tim Taler on May 14, 2018, 11:23:42 PM ...i forgot when i get the load error - ASR lamp is on, maybe that's important ? Title: Re: Searching for xdf file for A4 1.8T AT AMB'02 8E0909518F SW 360910 Post by: aleckerchner on February 03, 2020, 07:41:55 PM Sorry for the old bump, but this is the same setup i am working on. I am using the .XDF that was so generously provided here. However when i open my bin and ESKONF table, all i get is zero's. I just deleted all emissions and am looking to self tune them out. Not asking for someone to do it for me, but can someone check that the bin i pulled looks correct?
Thanks, Alec |