|
Title: Problem with OP-Com / Vaux-Com after flashing ECU Post by: opctim on June 28, 2018, 11:29:18 PM Hi guys,
as the title says, i've been tuning a corsa d opc / vxr. Checksum correction via Ksuite 2.13. Everything is running as expected, but OP-Com isn't working any more. It says that it cant communicate with the ecu. (I translated the error wordly from german - maybe its a little different. Ger.: "Keine Kommunikation mit dem ECM-Steuergerät") Any help is greatly appreciated. Cheers Title: Re: Problem with OP-Com / Vaux-Com after flashing ECU Post by: gman86 on June 29, 2018, 03:58:15 AM Hi guys, as the title says, i've been tuning a corsa d opc / vxr. Checksum correction via Ksuite 2.13. Everything is running as expected, but OP-Com isn't working any more. It says that it cant communicate with the ecu. (I translated the error wordly from german - maybe its a little different. Ger.: "Keine Kommunikation mit dem ECM-Steuergerät") Any help is greatly appreciated. Cheers What happens when you write the ori ? Title: Re: Problem with OP-Com / Vaux-Com after flashing ECU Post by: opctim on June 29, 2018, 04:36:28 AM Until now, I didn't try that. I'm guessing that it will work then.
KESS should be caring about the checksums. So what could it be then? Already tried Battery-Reset, no effect. Title: Re: Problem with OP-Com / Vaux-Com after flashing ECU Post by: KmosK04 on June 29, 2018, 06:14:17 AM KESS is unstable at those ECUs and also chcksm correction isn't ok. Use other tool and correct chcksm via WinOLS
Title: Re: Problem with OP-Com / Vaux-Com after flashing ECU Post by: opctim on June 29, 2018, 07:11:12 AM Thank you for your replies.
I corrected the checksum before flashing with winols. Is KESS forcing a checksum correction? If so, that could be the reason why opcom isn't working, right? |