|
Title: 16487 - Mass Air Flow Sensor (G70): Signal too High Post by: amd is the best on January 30, 2012, 02:35:36 PM I had this code after today. Any idea what would cause this or what to do to fix it? The TC light and ABS lights came on during a pull as well.
RS4 MAF using stock RS4 MAF scaling. Thanks! Nick Title: Re: 16487 - Mass Air Flow Sensor (G70): Signal too High Post by: phila_dot on January 30, 2012, 03:35:54 PM Sounds like KFMLDMX
Title: Re: 16487 - Mass Air Flow Sensor (G70): Signal too High Post by: s5fourdoor on January 30, 2012, 03:47:03 PM take the original table and multiply the entire thing by 4. thats what i did at least, i've never had the problem...
Title: Re: 16487 - Mass Air Flow Sensor (G70): Signal too High Post by: amd is the best on January 30, 2012, 03:57:24 PM Thanks guys! I just used the KFMLDMX and KFMLDMN values fromt the RS4 file. I'll do a few runs and see if it took care of this issue.
Title: Re: 16487 - Mass Air Flow Sensor (G70): Signal too High Post by: s5fourdoor on January 30, 2012, 04:05:46 PM set your entire KFKHFM table to 1.00 as well like in the RS4 file...
Title: Re: 16487 - Mass Air Flow Sensor (G70): Signal too High Post by: amd is the best on January 30, 2012, 04:17:19 PM set your entire KFKHFM table to 1.00 as well like in the RS4 file... Already done ;) Title: Re: 16487 - Mass Air Flow Sensor (G70): Signal too High Post by: tao13 on January 13, 2019, 10:04:37 AM Hi all.
I have the same problem but i saw it is activated only on 4 or 5 gear at highet speed and rpm. I have the stock MAF from BAm engine and the file is stock from BAM. I attached my stock KFMLDMX and KFKHFM. Is it a good option to make HFM all 1 like you said fee post ago or increase KFMLDMX? I think HFM will modify the partial adaption too, Correct? And other question , my load is higher than Load axis of HFM, do you think i must increase lastr value of axis too? Many thanks in advance |