|
Title: Me7.1 S4 d to m box bin Post by: maxc777 on September 02, 2018, 08:37:53 PM Hi guys,
I’m aware this has been covered a number of times in the past. Just wondering if it would be possible to write a M box bin file over my D box. (8D0907551D) Obviously I would have to change the airflow meter offset and table for the Bosch sensor. What about oxy sensors? M uses wideband I believe and post cat also? Thanks in advance. Sent from my iPhone using Tapatalk Title: Re: Me7.1 S4 d to m box bin Post by: nyet on September 02, 2018, 08:41:35 PM wideband no, post cat yes.
Title: Re: Me7.1 S4 d to m box bin Post by: maxc777 on September 02, 2018, 08:44:24 PM Oh ok good, so just code out the rear o2. Copy Bosch maf table and add the offset and it all should work?
Thanks. Sent from my iPhone using Tapatalk Title: Re: Me7.1 S4 d to m box bin Post by: nyet on September 02, 2018, 08:46:44 PM Oh ok good, so just code out the rear o2. Copy Bosch maf table and add the offset and it all should work? You may need to recode the ECU using VCDS to match your set up (no ESP, etc). |