|
Title: Cant read cable Post by: Nickcc123 on June 14, 2019, 12:35:09 PM I have Hex - Can cable from ross-tech. I updated my d2xx drivers also dont have it boot in intelligent mode. tried refreshing devices in nefmoto and still no luck reading the cable. Any help is appreciated!
Title: Re: Cant read cable Post by: ulek3pl on June 23, 2019, 05:50:52 AM I have ori and also dont work. In my case only china cables work fine.
Title: Re: Cant read cable Post by: dilly on August 26, 2019, 11:04:16 PM you need to install the correct drivers.
both my china cable and rosstech cable work perfectly fine Title: Re: Cant read cable Post by: nyet on August 27, 2019, 08:25:41 AM The latest "direct usb" drivers from ross tech do not work. Try the older USB drivers or the VCP drivers.
Title: Re: Cant read cable Post by: birchbark506 on August 31, 2019, 11:51:27 AM I installed the old driver with vcp, then followed the steps on Ross tech site and then Manually installed the port driver as website. And then used me7eeprom to read by odb
Title: Re: Cant read cable Post by: dilly on September 04, 2019, 08:27:20 PM i have two china cables. one ftdi from ebay and a hex+can vcds cable from china. has full version of vcds with updates lol 20$
both work flawlessly in nefmoto. i use the ftdi cable to read eeprom and what not in other programs + i think it uses the legit drivers too |