|
Title: B6 S4 (4.2 V8)Rear O2 Dependency to Start Post by: bamofo on October 31, 2019, 11:25:38 AM Ive been working on a project to remove the rear O2's completely from my car. But regardless of whats flashed to it (stock / nyet walkthough / other tests) if i unplug both rear O2 sensors the starter doesnt even click.
Is there another table on the ME7.1.1 i should be looking at to turn off this dependency? ROM is 8E0910560G-0030 which is posted by me on this forum. Im assuming all the V8 variants have the same logic on 7.1.1.. so it might help someone other then just me. Thanks in advance Title: Re: B6 S4 (4.2 V8)Rear O2 Dependency to Start Post by: nyet on October 31, 2019, 12:02:50 PM Did you try LSHHK=11 in ESKONF? (aka HSH)
Title: Re: B6 S4 (4.2 V8)Rear O2 Dependency to Start Post by: bamofo on October 31, 2019, 04:01:51 PM Did you try LSHHK=11 in ESKONF? (aka HSH) There were two bit pairs for Rear O2 bank 1 and Rear O2 Bank 2. Are you saying on top of that there is another one for LSHHK? or is that what this is? you only have mapped 7.1 and 7.5 so im going off piecemeal information off the site. I guess i can start 11 the sections idk what it is till the car starts... but idk if that will make a difference or why the car wouldnt start if rear O2's arent plugged in. Title: Re: B6 S4 (4.2 V8)Rear O2 Dependency to Start Post by: nyet on October 31, 2019, 05:12:04 PM There were two bit pairs for Rear O2 bank 1 and Rear O2 Bank 2. Are you saying on top of that there is another one for LSHHK? or is that what this is? you only have mapped 7.1 and 7.5 so im going off piecemeal information off the site. I guess i can start 11 the sections idk what it is till the car starts... but idk if that will make a difference or why the car wouldnt start if rear O2's arent plugged in. No, HSH and LSHHK are the same thing (iirc). I have updated the wiki to hopefully make it less confusing. |