|
Title: [SIMOS18] Leon Cupra R 300hp throttle not working after remap Post by: Khendal on November 09, 2019, 12:07:31 PM Hello, i facing this problem after flashed a remap to a Seat Leon Cupra R 300hp.
Starting the car, pedal doesn't work, remain in idle with engine on and if you press it... rpm don't raise. Anyone of you can suggest why? Regards Title: Re: [SIMOS18] Leon Cupra R 300hp throttle not working after remap Post by: Ron28 on November 09, 2019, 01:07:28 PM Did you rise all the single tl?
Title: Re: [SIMOS18] Leon Cupra R 300hp throttle not working after remap Post by: adam- on November 09, 2019, 04:45:18 PM What did you change?
Title: Re: [SIMOS18] Leon Cupra R 300hp throttle not working after remap Post by: prj on November 10, 2019, 09:51:17 AM Flash it to stock and don't flash shit files?
Title: Re: [SIMOS18] Leon Cupra R 300hp throttle not working after remap Post by: Blazius on November 10, 2019, 10:48:20 AM The charge control & DK control is telling you to fk off.. Something is wrong with that tune lol.
Title: Re: [SIMOS18] Leon Cupra R 300hp throttle not working after remap Post by: littco on November 10, 2019, 12:10:31 PM Flash back to stock
One of the torque maps will be out causing the problem. Title: Re: [SIMOS18] Leon Cupra R 300hp throttle not working after remap Post by: prj on November 11, 2019, 04:11:57 AM The charge control & DK control is telling you to fk off.. Something is wrong with that tune lol. Thank you once again for your completely useless post. For what reason are you padding your postcount? You probably have never even seen this ECU. Read again the load of bollocks you wrote, which can be copy pasted under every single post in this forum asking for help. Oh it's the good old "CHARGE & DK Control". jfc... The actual exact reason is that indicated torque in one of the conversion maps is higher than the indicated torque limiter. Title: Re: [SIMOS18] Leon Cupra R 300hp throttle not working after remap Post by: Khendal on November 11, 2019, 05:56:17 AM ... The actual exact reason is that indicated torque in one of the conversion maps is higher than the indicated torque limiter. Ok thank you very much... i will check again these maps... maybe somethings is escaped :-\ |