NefMoto

Technical => Tuning => Topic started by: aguplayer22 on March 22, 2020, 12:59:51 PM



Title: ME3.8.3 overrun cut Maps
Post by: aguplayer22 on March 22, 2020, 12:59:51 PM
Hey guys ,
i have a golf 2 with a 1.8t agu and play a litte bit with the ecu and the software. It's a 06A906108R , i have a mappack but there a no maps for the overrun cut delay time. Can anyone help me with a 2D Picture of the maps or the right location of these maps? or can anyone share his mappack with only the maps for some pops&bangs?


greetings


Title: Re: ME3.8.3 overrun cut Maps
Post by: aguplayer22 on March 23, 2020, 12:38:57 PM
i found some maps :

TVSAM.0 and TVSAM.1 for delay time before overrun cut

KFZW.0 and KFZWMN for the ignition angle


In TVSAM i set the time from 0.20 to 2.55 seconds and at the ignition maps i set the angle to -10 at lower load and from 3000rpm to 6800
But the car doesn't pop much in the idle when i rev it.

What map i have forgot for good pops and bangs?



Title: Re: ME3.8.3 overrun cut Maps
Post by: B5Quattrolife on March 25, 2020, 11:02:00 AM
not entirely sure but have you added fuel to the car because your condition of off throttle and delayed fuel cut may not be enough fueling to get it to ignite try adding fuel VIA KFLF at low load and high rpm


Title: Re: ME3.8.3 overrun cut Maps
Post by: prj on March 25, 2020, 04:12:25 PM
not entirely sure but have you added fuel to the car because your condition of off throttle and delayed fuel cut may not be enough fueling to get it to ignite try adding fuel VIA KFLF at low load and high rpm
That's some really shitty advice bro.
None of that is needed on any ECU, fuel cutoff needs to be delayed and ignition retarded.


Title: Re: ME3.8.3 overrun cut Maps
Post by: B5Quattrolife on March 25, 2020, 04:14:36 PM
Not seeing the map with logs it’s impossible to give any good advice.... so yes it’s actually bad advice


Title: Re: ME3.8.3 overrun cut Maps
Post by: eliotroyano on March 26, 2020, 06:57:17 AM
That's some really shitty advice bro.
None of that is needed on any ECU, fuel cutoff needs to be delayed and ignition retarded.

Then "schubabschalten" function OFF in that old ECU is really necessary?


Title: Re: ME3.8.3 overrun cut Maps
Post by: ulek3pl on April 09, 2020, 01:04:49 AM
I have all maps for pops bangs, hardcut and pseudo launch control

https://m.youtube.com/watch?v=AwPipZnw4i8


Title: Re: ME3.8.3 overrun cut Maps
Post by: misieksnk on August 07, 2020, 11:59:41 AM
I have all maps for pops bangs, hardcut and pseudo launch control

https://m.youtube.com/watch?v=AwPipZnw4i8

Could You write which maps You touch to make pops and bangs ?