|
Title: Simos6.2 rpm input 3.2 fsi AUK need help. Post by: Stoti on April 19, 2020, 05:22:10 AM Hello everybody . Is there any famiar with this ecu . Im having problems feeding ecu with rpm . Im swapping 2.7 liter biturbo engine and i need this ecu only to feed can bus for auto gearbox and esp . So i need only to see rpm . I have mounted engine speed sensor separate from 2.7 me7.1.1 and it reads and sends perfect signala to simos . Car starts runs for 5 secs and stops rpm on dash and vcds . i did not hooked camshaft sensors from 3.2 because 2.7 can only see 2 banks with 1 sensor. I have tried can hi can lo connection but my mistake that i was with Dbox manual. Rpm on dash work but Gearbox ,abs etc dont work. Also if there is somebody with this engine 3.2 AUK and can disconnect 4 cam sensors to report me is the engine keep running. I also tried 1.8t AWT plate on camshaft and connecting it to simos it gets signal like original but still not working . I have video but i cant upload it . Or if somebody with this engine can remove 4 cam sensors and start it to tell doez engne run more than 5 sec .
Title: Re: Simos6.2 rpm input 3.2 fsi AUK need help. Post by: Stoti on May 20, 2020, 01:58:15 PM delete wired up me7.1.1 with 4.2 rom and going to manual gearbox
|