NefMoto

Technical => NefMoto Software => Topic started by: Garbus19 on May 27, 2020, 11:58:48 AM



Title: I can't read the file from the ECU
Post by: Garbus19 on May 27, 2020, 11:58:48 AM
I can't read the file from the ECU


Title: Re: I can't read the file from the ECU
Post by: _nameless on May 27, 2020, 01:34:07 PM
.


Title: Re: I can't read the file from the ECU
Post by: Garbus19 on May 28, 2020, 12:32:52 AM
Hello, I know this is a stupid question but I have to read the file from the ECU I am a beginner in these matters greetings.


Title: Re: I can't read the file from the ECU
Post by: adam- on May 28, 2020, 12:41:02 AM
Also this:
Validation failed, ECU reports RequestUpload service is not supported. RequestUpload may have been disabled by aftermarket engine software.


Title: Re: I can't read the file from the ECU
Post by: Garbus19 on May 28, 2020, 09:27:31 AM
Hello, yes, the car is after the chip, but not too good because I have the ignition and a high charge around 3000 rpm and then it falls down. I bought one after the chip and I want to bring it all right, but I can't read the ecu file. Can anyone help me? I will add logs.
http://vaglogi.pl/log-115_118_lfEVrc6.html
http://vaglogi.pl/log-003_032_cQy96.html
http://vaglogi.pl/log-002_033_UkM82c.html
http://vaglogi.pl/log-002_020_tG0Xd.html


Title: Re: I can't read the file from the ECU
Post by: Jorgeminator on May 28, 2020, 10:01:41 AM
Come on... both Marty and adam- already told you why the file can't be read.


Title: Re: I can't read the file from the ECU
Post by: Garbus19 on May 28, 2020, 11:58:51 AM
So the file will not read because someone protected it from copying and I can even upload the original soft or go to the tuner to do everything again or I need to look for a second ECU.


Title: Re: I can't read the file from the ECU
Post by: _nameless on May 28, 2020, 01:43:33 PM
Hello, yes, the car is after the chip, but not too good because I have the ignition and a high charge around 3000 rpm and then it falls down. I bought one after the chip and I want to bring it all right, but I can't read the ecu file. Can anyone help me? I will add logs.
http://vaglogi.pl/log-115_118_lfEVrc6.html
http://vaglogi.pl/log-003_032_cQy96.html
http://vaglogi.pl/log-002_033_UkM82c.html
http://vaglogi.pl/log-002_020_tG0Xd.html


Title: Re: I can't read the file from the ECU
Post by: _nameless on May 28, 2020, 01:44:34 PM
OPEN THE ECU AND TAKE PICTURES OF THE FLASH CHIP


Title: Re: I can't read the file from the ECU
Post by: bamofo on May 28, 2020, 01:58:27 PM
OPEN THE ECU AND TAKE PICTURES OF THE FLASH CHIP

Marty how did you get to -222??

Topic response: bootmode read and get a galletto cable. or just get Galletto 1260 clone and be done.