|
Title: Wiring up VVT on 032 LP ECU Post by: vtraudt on August 08, 2020, 04:21:37 PM I need to wire up the VVT. ECU is 032LP.
Diagrams I found show "N205 Inlet Camshaft Control Valve 1" and showing pin 115 (green/white "gn/ws") for pin 2 and "D102 connection 2, in engine wiring harness" for pin 1 ge/sw (yellow/black, never figured out where that is terminating or what fuse that is on, but seems to supply +12V to N75, N249 and N205). Can someone confirm? If true, I would need to run "key on" +12V to pint 1 (yellow/black at VVT connector) and green/white to pin 115? Title: Re: Wiring up VVT on 032 LP ECU Post by: dal on October 10, 2023, 06:19:14 PM Yes, its the same positive (+) for these solenoids. Just make a good splice on the wire and its good to go.
The ECU controls on the negative side, to that pin you mentioned. Title: Re: Wiring up VVT on 032 LP ECU Post by: prj on October 11, 2023, 02:25:20 AM It should probably not be wired from key on ignition!
If you can see it is going to N75, N249, N205, then splice it into the +12V for any one of those. |