|
Title: need 06A 906 018D 1.8T AGU mappack/damos Post by: skullkidewaz on September 05, 2020, 05:14:35 AM Hello, i have a Problem with my ECU, i cant find a defintion File,
it's a 06A 906 018D with 0261204254 sw. on a Audi A3 1.8T. i know i have a PLCC44, but i buyed an M28F102 so i can desolder the OTP chip and change them to program my ECU with a EEPROM Programmer. I do my Research on the Internet but only get plcc44 0261 204 806 damos and it doesnt work(because of the other version). So does anyone has a Solution Damos/Mappack Adresslist or something. thanks Title: Re: need 06A 906 018D 1.8T AGU mappack/damos Post by: skullkidewaz on September 27, 2020, 08:11:58 AM Hello, i searched very long but found some Maps, and Online i found a few adresses, so i can adjust Boost Pressure, injection and can adjust bigger injectors and spark advance.
now i've got 0.8 bar boost pressure and the car drive very good, got an AFG gauge to see correct injection, and i think everything works fine. The new Problem is that i need to use another MAF sensor i dont have it yet, but soon i will buy one, because the target boost is 1.5 Bar (with bigger turbo etc.). Does anybody know where i can do this linearization in this old ECU? Title: Re: need 06A 906 018D 1.8T AGU mappack/damos Post by: eliotroyano on September 27, 2020, 03:29:09 PM Maybe a newer plug n' play ECU with 29F200 flash eeprom, CAN bus controller in board, that is flashable from OBD2 port with a nicely defined and more capable software, is some kind of not expensive solution that will move you one or two steps further for more flexibility and control capacity. A3 8L with 1.8T AGU pin 13 is not populated in OBD2 port. It arrives up to windshield wiring box. VW 06A906018CG or Audi 06A906018CJ for manual gearbox cars are nice options. I remember that are not expensive at all to find it.
Next move is to migrate to a ME7.5 ECU for total and precise engine control. |