|
Title: Read Me7.1 with 29f400BB Post by: Jannik07 on September 27, 2020, 05:18:42 AM Hello,
A friend of mine gave me hos ecu so I can tune it for him. Today i tried to read the Flash, but it did not work. My mpps and my ktag are only able to read the 29f800 I think. In my galletto i habe the Option to read a f400. But that did not work at all. Any solution? Ecu is taken from s4 b5 pre facelift. I put pin 24 to ground. Then Switched the Power source on. After 3-5 seconds i removed the ground Then Hit ecu data. But my galletto v54 wont read anything. Is there a way to read with ktag or kess? Greetings Title: Re: Read Me7.1 with 29f400BB Post by: BlackT on September 27, 2020, 05:32:27 AM Galleto 1260 can read it without problem.
I never used MPPS V16 in boot mode but it schould work also Title: Re: Read Me7.1 with 29f400BB Post by: Jannik07 on September 27, 2020, 09:00:41 AM 1260 thats only the eobd cable right?
So i need to prepare an Adapter for supplying connection to the ecu on the bench. Pin 21,62 and 3 12v Pin 1,2 ground Pin 43 kline Ground Pin 24 of the eeprom Switch on the Power supply, and disconnect Pin 24 after 3-5 seconds then Start the Tool? Thanks for your help. Title: Re: Read Me7.1 with 29f400BB Post by: BlackT on September 27, 2020, 11:21:20 AM Thats right ;)
Title: Re: Read Me7.1 with 29f400BB Post by: Jannik07 on September 27, 2020, 12:45:36 PM ok. I will try and report. Thanks again =)
Title: Re: Read Me7.1 with 29f400BB Post by: Jannik07 on October 04, 2020, 12:30:25 PM I tested it with MPPS V16 and it worked quite well.
All you need to know is, that you must Look for "Generic" in the manufacturer-list. When you try read it via Audi S4 or something you will fail ;) So thanks again ! |