|
Title: My first log Post by: s4man111 on December 19, 2020, 08:29:56 PM Can someone take a
Look at this . 2001 s4 b5 stage 3 . This is my first log using Me7. I’m getting p1129 overly rich code and boost cut down to 5-7 psi until I clear code and then I get normal boost. Title: Re: My first log Post by: s4man111 on December 19, 2020, 08:34:38 PM This was a second gear pull each time
Title: Re: My first log Post by: nyet on December 19, 2020, 08:43:40 PM 0 bytes.
Title: Re: My first log Post by: nyet on December 19, 2020, 08:44:11 PM forget logs, if you are throwing codes fix your trims first.
Title: Re: My first log Post by: s4man111 on December 19, 2020, 08:53:05 PM 0 bytes?? I went through a lot of trouble to set this up ,did it not log again ????
Title: Re: My first log Post by: nyet on December 19, 2020, 08:58:03 PM have the decency to check that they have useful information first, preferably with ecuxplot.
Title: Re: My first log Post by: s4man111 on December 19, 2020, 09:07:54 PM have the decency to check that they have useful information first, preferably with ecuxplot. I don't understand I started up visual Logger and loaded Ecu file and loaded up config file and hit log! Com port was correct too Title: Re: My first log Post by: s4man111 on December 20, 2020, 12:45:24 AM 0 bytes. OK so I figured out what I did wrong I was using a program called visual Me7 I don't know where the hell that came from but I wasn't using the regular Me seven logger!!! Title: Re: My first log Post by: nyet on December 20, 2020, 12:48:36 AM visualme7logger is a GUI front end, it requires the command line one as well.
You completely misunderstood everything here. |