|
Title: Audi TT Mk1 Bench Key Programming Post by: JakeGT on March 27, 2021, 08:34:50 AM Hi,
Does anyone know if I need anything else connected on the bench to allow me to adapt new keys? Currently have cluster, ECU & key all matched & wired up. Whenever I try to adapt a new key in VCDS I get an error on Channel 21. I've followed the process correctly but can't figure it out ??? Any help appreciated. Thanks. Title: Re: Audi TT Mk1 Bench Key Programming Post by: macxxx on March 27, 2021, 11:35:47 PM Do you have correct pins? Is there communication beetween cluster and ecu? ( can and W wire )
Title: Re: Audi TT Mk1 Bench Key Programming Post by: BlackT on March 28, 2021, 12:09:49 AM If it is a immo 3, than you need a new keys, or put new ID48 chip in old keys.
You can use old keys, but only with pin from that car Title: Re: Audi TT Mk1 Bench Key Programming Post by: stuydub on March 28, 2021, 03:08:30 AM Hi, Does anyone know if I need anything else connected on the bench to allow me to adapt new keys? Currently have cluster, ECU & key all matched & wired up. Whenever I try to adapt a new key in VCDS I get an error on Channel 21. I've followed the process correctly but can't figure it out ??? Any help appreciated. Thanks. to adapt keys on bench obvs need ECU and CLUSTER rig connected/joined (this setup pairs ecu /cluster/keys)..u you need the chip reader ring from barrel connected to ECU and cluster (i dont have CAN wires connected for edc 15 me7)..immo 3 u need SKC for old keys or new id48 chip (as stated above) or u can use a immo2 key as these are unlocked untill paired to immo 3.. |