|
Title: Bench setup suggestions Post by: Sandstorm3k on July 03, 2021, 10:40:06 AM I've got another extremely noob question - i know how to do boot mode using various tools. But i simply cannot get a read or write to the EEPROM on my bench.
Perhaps anyone could shed some light on how to wire this up properly, as i've tried various things for over a few hours now and i can't find a proper answer. I've got all the hardware required, and have made my own "harnass" as far as i thought is required, but it will simply not work. Title: Re: Bench setup suggestions Post by: fknbrkn on July 03, 2021, 12:30:53 PM Get one of these
https://www.amazon.co.uk/MyCor-Media-ME7-Direct-Control-Devices-KWP2000/dp/B07CLMKXZT Car cigarette adapter with 5a fuse or 110-220v 1a adapter from any router or ip cam Switch Check wiring. Do not forget pin 21 (and 121 if you planning to flash in obd mode) Power on - vcds. If its ok run bootmode Title: Re: Bench setup suggestions Post by: Sandstorm3k on July 03, 2021, 01:08:37 PM I think I've just wired mine up wrong, I'll play with it once more else I get one of these.
If i look at this correctly i only need to put 12v and ground on pin 1, 3 and then wire up the rest from the KKL cable. Thanks a ton for the suggestion Title: Re: Bench setup suggestions Post by: fknbrkn on July 04, 2021, 12:45:58 AM Just google me7 boot mode picture
More pins should be wired aswell Title: Re: Bench setup suggestions Post by: Sandstorm3k on July 05, 2021, 08:13:49 AM Get one of these Kinda done messing with these loose wires, I've ordered one. Thanks for the suggestion!https://www.amazon.co.uk/MyCor-Media-ME7-Direct-Control-Devices-KWP2000/dp/B07CLMKXZT Car cigarette adapter with 5a fuse or 110-220v 1a adapter from any router or ip cam Switch Check wiring. Do not forget pin 21 (and 121 if you planning to flash in obd mode) Power on - vcds. If its ok run bootmode |