NefMoto

Hello everyone. Help me please! How to shift the load value. Through Tuner pro, I don't understand how to do this? (http://nefariousmotorsports.com/forum/index.php?action=dlattach;topic=970.0;attach=30371;image)

By creating the map with axis values

Could you tell us in detail how to create it? All I can do is transfer maps from Winols to Tuner Pro

Easy, look at defined XDF and see. Usually map axis which is used for just one map is extremely close to the map itself. From memory i believe just a few lines above the map itself in raw hex.

If I throw off the XDF file and the firmware you can find it and then explain to me how you found the axis would it be good with screenshots?

Here are screenshots of axes addresses

You have literally already answered your own question - just put them into a parameter

Excuse me, but I don't understand a little what parameters to enter and where? As I understand it, I need to create a new map, transfer all addresses of the MIOP map to General and Rows and find the correct address for the Columns axis like this?

Not all, just the axis address and other relevant stuff such as conversion etc.

Excuse me again. It's easy for you, but I'm new to it. But I want to learn. Let me create a new map, can you check it or not?

Do I take the first General hex address with MIOP?

Attach files, i'll show you once. You already have the addresses so it's even more easy.

Here you go.

Now I understand everything. Thank you very much !!!