|
Title: Clone ME7.1.1 Post by: RS6c5 on August 15, 2021, 02:06:38 PM Hello all,
I want to clone my Audi RS6 C5 ECU. Ref: 4D1 907 558 (0004) Bosch ME7.1.1 HW: 0261207857 SW: 1037366304 I have a KTag clone, so I tried to read my ecu in boot mode but it's an echec. I have no errors while reading, however the eeprom file (ST95040) is empty. after several unsuccessful attempts I conclude that the method is not good. Could you tell me a suitable method without having to invest in professional equipment Thanks for your precious advice. Title: Re: Clone ME7.1.1 Post by: RS6c5 on August 25, 2021, 01:38:29 PM Hello,
after many more hours of research and testing I still can not read my ecu in full :'( I also try using "ME7 EEPROM" without success. Please help me, I would really like to be able to save my ecu before starting tuning. Thanks Attached my extraction Title: Re: Clone ME7.1.1 Post by: R32Dude on August 25, 2021, 05:26:27 PM I tried one of these on a different ecu
https://m.aliexpress.com/i/32355336386.html Needs a slight mod with soldering iron to get 5v onto the correct pin. After that, clip onto eeprom with ecu power off And read/write to your hearts content. Title: Re: Clone ME7.1.1 Post by: bamofo on September 02, 2021, 08:19:02 AM Full Clone will need Boot mode and two cables. I typically always use Galletto 1260 for the ROM and EEPROM tool with a cheap KKL cable off ebay. Command for that would be based off what chip it has...
|