NefMoto

Hello doez anybody sniffed can messages for cruise conttrol stalk on b6 , b7 ,4f ,4e i have tried but with no sucsess , connected direct to steering wheel electronics on 500 kbps powertrain bus and  convince 100 kbps bus but module keeps silent or dont transmit commands till vcds ask . I have tried modifying CWGRABH but ecu sees only master switch byte nothing else . Or i have to call them like vcds but im affraid that can breakdown comunication when diagnostic is active .

what are you looking for? How to sniff, the CAN message IDs and payload?

The FR doc should have the expected CAN IDs and payloads.

Looking fot id and data for set,reset resume and similar to add it in micrococontroller and activate separate pin like standart m7.1.1 2.7tt Ecu.

FR has it
CAN module

CAN CC wont work on me 7.1.1

I dont want to control ecu over can , i want to build my own controler based on messages from 4F platform and convert it to analogue signals to me 7.1.1 and i think 7.1.1 can work with can based cc just my steering colum doez not transmit messages to be used. I build arduino based engine fan controller with pwm and ac pressure controled over can last thing is to combine cruis control to it . Also it have its own Display that i plan to add boost to it .

Did your steering wheel, steering wheel module come from a car that used CAN for CC controls?

Me7 FR
Page 675, I don't have time to look but there schould you find answer

2.7tt is swapped in a6 4f thanks to marty and prj it works with 6hp19a auto gearbox .  BlackT i have downloaded it and splitet do 3 parts for translate . I cant belive how stupid i am that i dont read this document before everything else . Thank you guys.

CWGRABH=3
10 pin white connector engine bay disconnector in my case was blue/green  (3.2FSI), me7.1.1 equipped car is white/black to pin38 M7.1.1