|
Title: Audi 4F 4.2 MPI problem with APS G79 signal to low Post by: BlackT on March 08, 2022, 12:04:10 PM short long story, I need to get some CAN_BUS data from 4.2 M7.1.1 ECU so I connect it to my car (2.7ARE)
I connected 4.2 ECU to accelerator pedal, grounds and signal pins 3,4,5,6. But 4.2 ECU does not regonized pedal. So i discconcted pedal form 2.7 and only connect it to 4.2. Now 4.2 ECU see G185, but not G79 I get this error: 18038 - Accelerator Position Sensor (G79): Signal too Low P1630 - 35-00 Pedal is okay, wires are good. I use this shematic from attachment Is this ECU fired or I miss something? 4F0907559 Title: Re: Audi 4F 4.2 MPI problem with APS G79 signal to low Post by: BlackT on March 09, 2022, 12:42:16 AM I still have no clue what is happening here ???
How this could make problem or burn something in ECU? I see on PCB there is a 10 k resistor in ECU between MCU and pedal signal, that is enough protection to ADC in MCU ??? Pedals should be same on every ME7 or am I wrong? |