NefMoto

Technical => Reverse Engineering => Topic started by: 1gcrazy on January 25, 2023, 12:40:38 PM



Title: Clearing DTC's in ME7 eeprom
Post by: 1gcrazy on January 25, 2023, 12:40:38 PM
Is there a memory location specific to all ME7's where you can clear(with FF's) all current DTC's without hooking up a scantool?
Wasn't quite sure where to put this but I figured all the smartie pant's hang out here. :D


Title: Re: Clearing DTC's in ME7 eeprom
Post by: stuydub on January 25, 2023, 10:55:38 PM
Yes there is a p code location 16x72 table will need to find fault code then use some maths to work out location of area to FF or 01 it to become inactive.... Use search to find the solution's as it posted on the forum


Title: Re: Clearing DTC's in ME7 eeprom
Post by: stuydub on January 25, 2023, 10:56:28 PM
Yes there is a p code location (16x72 table in my KPs) will need to find fault code then use some maths to work out location of area to FF or 01 it to become inactive.... Use search to find the solution's as it posted on the forum


Title: Re: Clearing DTC's in ME7 eeprom
Post by: prj on January 26, 2023, 03:01:30 AM
I think you completely missed what he said.

And the answer is no, code will be required.