|
Title: MED17.5 There is a large gap between the actual torque and the requested torque Post by: yangbohan on April 02, 2023, 09:16:12 PM Can you help me?I calculated and scaled KFMIRL and KFMIOP through the EXCEL table. There is a big gap between the calculated torque and the request, which caused the transmission oil pressure to not be controlled correctly. And there is a big shock phenomenon when upshifting，Replaced the K04 supercharger and upgraded the DQ500 four-wheel drive hardware,Where is my problem?
Title: Re: MED17.5 There is a large gap between the actual torque and the requested torque Post by: h2esk on April 03, 2023, 02:35:48 AM MDNORM?
Also lower your load, you are running out of MAP sensor range. Title: Re: MED17.5 There is a large gap between the actual torque and the requested torque Post by: yangbohan on April 03, 2023, 05:16:17 PM Thanks! My request does exceed the maximum range, replace the pressure sensor with a higher range? The load can only be calculated to 2550=191%=400NM? In which module is this calculation in the function manual?
|