|
Title: Why is this not flashing? Post by: nubtuner on July 07, 2012, 11:00:39 AM Connecting...
Starting slow init connection. Connecting to address 0x01. Slow init succeeded. Switching to KWP1281 session. KWP1281 connect info: 8D0907551T 2.7l V6/5VT G 0003 Connected Disabling Windows sleep mode. Writing ECU flash memory. ECU reports programming session preconditions have been met. Negotiating communication timings. Successfully changed to new communication timings. Requesting security access. ECU reports that security access request was rejected. Starting diagnostic session. Successfully started diagnostic session. Negotiating communication timings. This is what im getting and that is all i get. is there something im doing wrong? Title: Re: Why is this not flashing? Post by: nubtuner on July 07, 2012, 11:08:04 AM 07/Jul/2012 11:04:55.658: LOG: Could not construct valid message from received data: InvalidChecksum
07/Jul/2012 11:04:55.659: LOG: Removing first byte from the receive buffer to try to create a valid message. Removed: 0x07 07/Jul/2012 11:04:55.687: LOG: Could not construct valid message from received data: InvalidChecksum 07/Jul/2012 11:04:55.687: LOG: Removing first byte from the receive buffer to try to create a valid message. Removed: 0x07 07/Jul/2012 11:04:55.718: LOG: Could not construct valid message from received data: InvalidChecksum Judging by this, i have invalid checksums? Title: Re: Why is this not flashing? Post by: Vdub-dub on July 07, 2012, 11:22:32 AM at a guess as checksum is incorrect reckon need boot mode with galletoo etc to write a good map on
Title: Re: Why is this not flashing? Post by: nubtuner on July 07, 2012, 11:29:04 AM Would it work if someone were able to update the checksums?
Title: Re: Why is this not flashing? Post by: Vdub-dub on July 08, 2012, 10:57:46 AM as you have a bad checksum already on there may need boot mode to write to it but not with nefmoto sw
|