|
Title: Need Help 1.8T AUM Post by: Kaipan61 on October 05, 2023, 02:59:38 AM Hello
I have a problem with my kit car (similar to Lotus Seven). It has 1.8T AUM built in. I converted the engine to a dry oil pan. After remodeling, I discovered this the oil pressure is too low. The PACE pump was described for engines up to 2.0l. Apparently does not apply to engines with turbo and piston cooling. It is not due to lack of space possible to install a larger pump. So I converted the translation and used VagCom the idle speed increased. Now the oil pressure is approx. 1.1 bar. This is at the border. I would like to increase the idle speed to around 1050. As I read, several influence Maps the idle speed. Would it be possible for someone to adjust Flash.bin to the desired speed? Title: Re: Need Help 1.8T AUM Post by: adam- on October 05, 2023, 05:01:15 AM Idle speed is covered in the wiki.
Title: Re: Need Help 1.8T AUM Post by: aleks19411 on October 06, 2023, 03:38:24 PM Hello Where is the source file? How can I help you in this case?I have a problem with my kit car (similar to Lotus Seven). It has 1.8T AUM built in. I converted the engine to a dry oil pan. After remodeling, I discovered this the oil pressure is too low. The PACE pump was described for engines up to 2.0l. Apparently does not apply to engines with turbo and piston cooling. It is not due to lack of space possible to install a larger pump. So I converted the translation and used VagCom the idle speed increased. Now the oil pressure is approx. 1.1 bar. This is at the border. I would like to increase the idle speed to around 1050. As I read, several influence Maps the idle speed. Would it be possible for someone to adjust Flash.bin to the desired speed? Title: Re: Need Help 1.8T AUM Post by: Kaipan61 on October 07, 2023, 12:14:17 AM Hello
I read the wiki, but there are several maps involved. NLLM - idle RPM, NFSM - idle RPM while in gear, KFMRES - idle torque reserve. Is it enough to change NLLM? I have to download Flasch first. Because of just raise idle and my age (66), I don't want learn the whole procedure from flash download to checksum .I use old max232 interface, so I wait for KKL interface because it is not recognized by Nefmoto .I only have some experience with microchip assembler and Arduino. I would like to get help from someone.I'm using the old max232 interface, so I'm waiting for the KKL interface as it's not recognized by Nefmoto.If I download the Flasch.bin, I will get in touch. It is " 06a906032hj 002 " Title: Re: Need Help 1.8T AUM Post by: adam- on October 07, 2023, 01:00:45 AM See attached - stock file with only raised idle to 1100.
Title: Re: Need Help 1.8T AUM Post by: adam- on October 07, 2023, 01:03:59 AM Note if it's in a swap you'll need all the deletes etc. Got files sitting, just give me a PM.
Title: Re: Need Help 1.8T AUM Post by: Kaipan61 on October 07, 2023, 02:31:22 AM Thank you very much. If there are any problems, I will contact you.
|