|
Title: ME 7.5 After flash with mpps car runsfine but not able to flash anymore? (FIXED) Post by: beyda on October 31, 2023, 04:02:52 PM Hey guys,
i have a problem, so i flash my car several times with mpps but after my last flash im not able to write via obd anymore. mpps says ecu not found, read id also not work. i can log the car with vcds and i have no DTCs. so what went wrong? the only diffrent i made is to put a new clutch in it so i thinks this can not cause the problem. i try to remove the dashfuse -> not working checked the harness -> all ok checksum is ok Title: Re: ME 7.5 After flash with mpps car runsfine but not able to flash anymore? Post by: nyet on October 31, 2023, 11:09:10 PM boot mode or spare ecu.
Title: Re: ME 7.5 After flash with mpps car runsfine but not able to flash anymore? Post by: JeanAwt on October 31, 2023, 11:42:05 PM some china mpps are limited....
Title: Re: ME 7.5 After flash with mpps car runsfine but not able to flash anymore? Post by: aef on November 02, 2023, 12:33:45 AM use nefmoto software if you have vcds
Title: Re: ME 7.5 After flash with mpps car runsfine but not able to flash anymore? Post by: beyda on November 04, 2023, 10:26:21 AM Thx for reply,
Nefmoto is not working on both pc I have ko idea what I am doing wrong. I got an spare ecu with same sw and hw numbers. So can I connect an flash my file on these with obd? Or need to do immo off? Title: Re: ME 7.5 After flash with mpps car runsfine but not able to flash anymore? Post by: beyda on November 04, 2023, 10:40:13 AM Yesterday I was able to flash and all was good.
But today : ecu not found. When I flash or read ecu Id I hear my original vw amplifier in the rear making ticking noise. I unplucked it but it makes no different to get connections to ecu. What the hell is going on this car. Title: Re: ME 7.5 After flash with mpps car runsfine but not able to flash anymore? (FIXED) Post by: beyda on November 04, 2023, 11:33:55 AM fixed the problem.
i screwd up my ecu and do some high complex NASA shit... Pull out my Heatgun and cooked it by 350°C for about 30 seconds. now it work... |