|
Title: Spare ECU doesn't get 12V input from the car Post by: tmc on January 09, 2024, 02:53:45 PM I bought a spare ECU MEG17.9.12, and I took firmware with immo off from online resources, and write it to ECU using KTAG. However, when I connect it to the car, and I measured the voltage on the large 2 pins as show in picture below, there's no 12V present. What could be the problem? given that, the original ECU I have does show 12V.
Also, there was only 1.86V present in the spare ECU instead of 12V. any thoughts what is causing this? I have Accent 2012, 1.4 Engine, Automatic transmission (http://i.imgur.com/yNXelHZ.jpg) |