NefMoto

Im looking for an Definition file for an 06 Turbo S Me7.1.1 0261207696 1037382338 8te2ass20000188

I want to delete complete tcu from can bus.
I think cw_can_r will do this.

I located :
CW_CAN_R_0_A  at 8136F8
CW_CAN_R_1_A at 8136FA

But im not sure about this and what I need to change I had a Look at the FR and I think 0A and 1A is not enough?

I hope someone can help me

This should do the trick

Thanks, for the help.

Yesterday I looked at it again with an mappack and I just changed the last two bits to 0  from cw_can_r  and changed cwgc to 15 . It works without abs light

I think you basically did the same think ? I have a Look at your file later then I have my PC winols.

Only error left is p0501 speed Sensor implausible signal, maybe a lose plug or something to do with the manual swap.

Set cwggvfzg =2 and that will pull vss from can via wheel speed sensors

2 is not possible max value is 1 but then it will take vss from abs and this will work too or I understand the FR wrong ?

ggvfzg max value is definitely not "1". Just my two cents.

Look at 0x10453, change 0x18 to 0x02

Ofc you are right, not sure what I did maybe I tried editing in 1bit bin  ::)


You are absolutly right with this one.

Now I am at CWGGEGAS and so on for the clutch switch.

Again did some testing and after some driving Im still getting P0501 .
So changing it with CWGGVFZG does not work is my only Option can Box?

Do you have the vehicle speed in the instrument cluster ?

Yes speedo is working, but then I Look at the Instrument Cluster Pinout there is no Pin for Speed Signal, works with can.
Same for the ME7.1.1.

Don_t put CW_CAN_R to zero if you have ABS
Look in FR and only change bits that are for TCU

Abs is active in CW_CAN_R,  I only changed bit 0  and 1 to 0 in FR  they are for the Gearbox can.
The P0501 Code was there before changing anything.

Even the cruise control is working then p0501 is gone and with it on p0501 will not return, then I drive without cc it comes back and cc with the fault Set will not work.