NefMoto

Noob Zone => Noob Questions => Topic started by: bombis on August 12, 2024, 07:48:38 AM



Title: KFZW my ignition angle is too low
Post by: bombis on August 12, 2024, 07:48:38 AM
I want to run 11 degree timing, my KFZW values. Why am i only getting 6 degree?


Title: Re: KFZW my ignition angle is too low
Post by: bombis on August 22, 2024, 01:49:41 PM
Runs stronger now. Around 9 deg timing at 5000rpm+ WOT
Adjusted kfmizuof and kfmizufil to 100. Disconnected MAF sensor.


Title: Re: KFZW my ignition angle is too low
Post by: bombis on September 09, 2024, 12:15:04 PM
Timing was fine when i disconnected maf sensor.
I want to run with MAF,(because of ESP light etc) but now timing is unsable, why?


Title: Re: KFZW my ignition angle is too low
Post by: Audirama on September 10, 2024, 04:35:45 PM
I am wondering about this too,

I am running on e85 blend e60 with no knock and still getting less timing than KFZW, i will get 20-21 degrees when targeting 23-24, I've been trying to isolate what else influences the actual ignition timing


Title: Re: KFZW my ignition angle is too low
Post by: bombis on October 06, 2024, 12:34:28 PM
1. kfmdadp, kfmdaro, kfmdaros increase works best :) (thanks to gremlin for map locations)
2. I think FF Kfmizouf/kfmizufil works, but Wiki says wrong way.
3. TMAR increase might work, according to the forum