|
Title: How to set the KSTT map for LPG Post by: Kacpern on October 21, 2024, 05:43:10 AM Hello everyone, I'm looking for guides and advice on how to decorate the KSTT map.
Problem At a temperature of 0 to 20 degrees, the starter turns for 2-3 seconds before it starts, then it starts and runs well (holds idle speed), has the power to drive. The starting dose is significantly reduced compared to gasoline. 0-5 degrees 6.5ms 10-15 degrees 5ms 20 degrees 4 ms These are the best results. I tried changing them up and down by 0.1 ms many times, but it didn't help. Title: Re: How to set the KSTT map for LPG Post by: Kacpern on October 24, 2024, 08:22:03 AM Or in other words, how to measure whether there is too little or too much fuel when the lambda probe does not work because it is cold?
LOG AND MAP 0 -33°C 1 -18°C 2 -9°C 3 -1°C 4 15°C 5 21°C 6 32°C 7 57°C 8 69°C 9 73°C 10 98°C 11 132°C Title: Re: How to set the KSTT map for LPG Post by: Kacpern on October 26, 2024, 12:27:56 PM Nobody knows anything?
|