|
Title: How to make perfect constant plsol BoostPressureDesired Post by: radzio3747 on November 16, 2024, 02:07:09 PM Hi, i have question how to make constant plsol. What maps are plsol dependent? KFTARX , KFFLLDE ? I have funktionsrahmen, but I don't know what exactly to look for to set the given boost equal to the table. Does the 5120 hack affect this? In my software, the boost is set to be equal, but there is a 5120 hack. The car should have a boost of 1 bar, i.e. load 170. I want to set KFMIRL and LDRXN too same much higher, e.g. 200, and set the limit to KFLDHBN
(https://zapodaj.net/images/1e456495827f4.jpg) Title: Re: How to make perfect constant plsol BoostPressureDesired Post by: radzio3747 on November 16, 2024, 10:11:19 PM I want to learn how to do this without the 5120 hack. Is it possible?
Title: Re: How to make perfect constant plsol BoostPressureDesired Post by: radzio3747 on November 16, 2024, 10:17:25 PM This is my wife's BoostPressureDesired (plsol) in 1.8T BEX. And I want to make the boost desired constant.
(https://zapodaj.net/images/3fedecfc892c1.jpg) Title: Re: How to make perfect constant plsol BoostPressureDesired Post by: fknbrkn on November 16, 2024, 10:39:23 PM Limit with hbn + flat arx
5120 won't affect this Title: Re: How to make perfect constant plsol BoostPressureDesired Post by: radzio3747 on November 17, 2024, 08:06:39 AM ok thanks, I'll try it
Title: Re: How to make perfect constant plsol BoostPressureDesired Post by: prj on November 17, 2024, 03:29:45 PM Btw there is zero reason to run flat boost request, I would say it's stupid.
From drivability standpoint you want flat torque and not flat boost. |