|
Title: How would I begin to do a checksum on Simos 3.3 Post by: Rick81 on November 18, 2024, 04:38:41 PM I deleted a dtc did checksum flashed it everything went well starts up fine.
Winols doesn't seem to do all the checksum for all dtcs . I have more dtcs to delete. Where would I start or if I was to correct it manually is there a program to use .Am I correct That Simos 3.3 is an 8bit ? Kind regards Title: Re: How would I begin to do a checksum on Simos 3.3 Post by: cherry on November 18, 2024, 10:56:33 PM Just contact EVC if there is a problem in Winols checksum, they have great support.
Title: Re: How would I begin to do a checksum on Simos 3.3 Post by: Rick81 on November 19, 2024, 11:49:09 PM I get that . I would like to learn how to do it manually . If i went down this route is the checksum actually in the map itself. Does it start or end with a zero? And when checksum is corrected does the modified file just need the checksum to read the same as the original file or should i say match up. If i use tuner pro from what i understand it will only except a bin file and not just file well the free version anyway
Title: Re: How would I begin to do a checksum on Simos 3.3 Post by: Rick81 on November 20, 2024, 01:35:55 AM On hex editor I'm comparing files. If I go to checksum section in picture attached I'm not sure what it means
Title: Re: How would I begin to do a checksum on Simos 3.3 Post by: Rick81 on November 20, 2024, 01:43:03 AM On hex editor I'm comparing files. If I go to checksum section in picture attached I'm not sure what it means |