|
Title: 03C 906 016 DG (MED17.5.5) table setup pinout ? Post by: H2Deetoo on March 30, 2025, 04:24:39 AM Hi everyone,
I tried to make a table setup to communicate with an ecu 03C 906 016 DG which is MED17.5.5 using the pinout info I found online. Unfortunately I was not able to communicate with the ecu, it would not even start broadcasting canbus messages. Does anyone here have the correct pinout for this ecu? Regards, H2Deetoo Title: Re: 03C 906 016 DG (MED17.5.5) table setup pinout ? Post by: terok on March 31, 2025, 01:09:11 AM Pin 1 and 2 = gnd
Pin 3 and 5 = 12V Kl.87 (from main relay) Pin 67 = CAN low Pin 68 = CAN high Pin 87 = 12v Kl.15 (ignition) Pin 92 = 12v Kl.30 (continuous) Pin 69 = main relay control, if you want to use it. Taken from Golf 6 CAXA schematic. Title: Re: 03C 906 016 DG (MED17.5.5) table setup pinout ? Post by: H2Deetoo on March 31, 2025, 01:55:07 AM Thank you for this info.
I have seen to have found my problem though, apparently I was messing with a piggyback ecu module instead of the real ecu. This is the first time I have seen or heard of such piggyback ecu, this one is from ABT. So it seems this car is "tuned" already using this piggyback system. Thanks again, H2Deetoo |