|
Title: Galetto Intermittent Behavior – Win7-32bit Post by: trichard3000 on August 07, 2012, 08:34:09 PM I’m trying to make sure that I can access boot-mode flashing if necessary. Most of the issues that people report with this cable/software is that they can’t get past the “Boot Mode Inactive” error.
In my case, I can get past that but then things get goofy. Sometimes I can read the ECU info and sometimes it just errors out. If I try to write an image, again sometimes it errors out right away, other times I get a scrolling status bar. I’ve never gotten it to put a whole flash on the box, though. Any pointers on this kind of intermittent behavior? Title: Re: Galetto Intermittent Behavior – Win7-32bit Post by: Stompen on August 09, 2012, 11:24:21 AM If you just get a rolling bar and no readout/flash, you most likely are grounding the pin too long. Remove the ground when you see the bar start... write, hit connect again without disconnecting the ecu.
Title: Re: Galetto Intermittent Behavior – Win7-32bit Post by: nyet on August 09, 2012, 11:27:51 AM The boot pin only has to be grounded AS you power up the device. Remove it BEFORE you push any other buttons.
|