NefMoto

I can't connect in nefmoto when abs n brake light are flashing. To connect while lights are on I must turn ignition on and click connect and then turn key off and it will connect but say it can't flash. Now when the abs n brake lights are out it flashes and connects fine unless lights come on in middle of flash then it messes up

Is there a trick. Can I remove cluster or pull fuse and it work. I have tried everything.

Thanks in advance on any input

Nefmoto can not connect while abs & brake light activated

You can try pulling the "K-Line" fuse. That should prevent any modules from talking to the ECM.

Corrupted immo i guess after flashing bad csm'ed file or after flash failure.

ok I removed the KL fuse labled #5 noting diferent happend. Also I read a few forums like said removing cluster and or fuse for cluster would work but all the cluster fuse does is turn off the LCD screen. Somone else had told me its cause my abs ecu is not making proper connection to the cluster. I just got a galletto cable in the mail yesterday and dont have a clue really on using it

This is a very good reason to stop what you are doing...

Well how do you learn then?

Under the Wiki link in the top right corner there is a wonderful tutorial on using the Galetto 1260 Cable. There is also quite a bit of other wonderful knowledge there also. I myself learned quite a bit from the Wiki page.

http://www.nefariousmotorsports.com/wiki/index.php/Galletto_1260_Flashing_Cable (http://www.nefariousmotorsports.com/wiki/index.php/Galletto_1260_Flashing_Cable)

Ok wanted to update that removing the abs ecu harness from the abs unit under the hood did the trick and it flashes and connects all the time.

Now just need some to checksum files for me