|
Title: Variable cam disabling Post by: cam on September 11, 2012, 12:15:48 PM Hello,
need help with complete disabling of variable cam in 06A906032HJ. I have GT3071R installed and have troubles with this :( Can anybody help me? Title: Re: Variable cam disabling Post by: Gonzo on September 11, 2012, 02:14:20 PM CDNWS = 0
Title: Re: Variable cam disabling Post by: cam on September 11, 2012, 02:19:08 PM It is codeword for camshaft control, do you mean that i will disconnect camshaft control valve?
I think that is sw solution here ... Thank you Title: Re: Variable cam disabling Post by: Gonzo on September 11, 2012, 07:16:07 PM Setting that to 0 should disable completely.
I believe its been covered around here before. Title: Re: Variable cam disabling Post by: cam on September 12, 2012, 01:07:30 AM Tried to find and no results :(
Title: Re: Variable cam disabling Post by: professor on September 12, 2012, 01:11:01 AM On what ECU/version did you try to find it, perhaps can help you.
Title: Re: Variable cam disabling Post by: cam on September 12, 2012, 10:21:46 AM 06A906032HJ / 1037360646
When i disconnecting valve electricaly i have DTC ... Title: Re: Variable cam disabling Post by: professor on September 12, 2012, 10:42:27 AM 06A906032HJ / 1037360646 CDNWSWhen i disconnecting valve electricaly i have DTC ... @loc: 0x181AF Title: Re: Variable cam disabling Post by: cam on September 13, 2012, 01:44:49 AM Correct, i have set to 0 and DTC still shows.
Title: Re: Variable cam disabling Post by: Aragorn on September 13, 2012, 04:23:25 AM I'm interested in this too.
I'm converting my car to ME7.5, and it doesnt currently have VVT, so i've no valve to plug in. I've read before about CDNWS=0, you also need to mess with the timing tables KFZWOP/2 (making them equal), as my understanding is that CDNWS just turns off the diagnostics for VVT, and the code still runs and still attempts to adjust the valve and alters the timing between the two maps. I guess so long as the fuelling is correct and its not turning off fuel trims, then it should just be a case of hiding the Fault code? cam: are your fuel trims working even though the fault code is present? Title: Re: Variable cam disabling Post by: elRey on September 13, 2012, 05:39:03 PM Correct, i have set to 0 and DTC still shows. which DTC is still showing? Check out ESKONF Title: Re: Variable cam disabling Post by: Gonzo on September 13, 2012, 06:55:05 PM Use a resistor.
Title: Re: Variable cam disabling Post by: aef on September 14, 2012, 01:55:14 AM |